The AquaPure system uses a unique Tri-Sensor to measure flow, temp and salinity. By using a separate sensor, the accuracy of the salt reading maintained despite the condition of the cell.
Most (if not all) of the other systems measure the salt level by measuring conductivity through the cell. There is a problem with that method. If the cell gets scaled up or fails for some reason, it can give a false low salt reading, even if the salt level is OK. Suppose you add a bunch of salt to the pool (thinking the salt level is low when it is actually OK). What happens? Yup . . . now you have a salt level that is way to high and now you have to drain the pool down.
The Tri-Sensor mounts in the plumbing prior to the cell and measures flow, salt level and temperature.
2. In-House Manufacturing
Without a doubt, the most critical part of the salt system is the cell. In any system, the cell is the component that is most prone to failure, if not manufactured to the highest standards. It is also the most expensive part to replace. When Jandy purchased the AquaPure system, the purchased the entire manufacturing company, Huron Tech. Huron Tech manufactures its own titanium plates and heat exchangers for their salt systems and heat pumps. Keeping this manufacturing process in house insures quality control and also keeps the cost of replacement parts down.
Specs
Size:
For pools greater than 15,000 Gallons
This unit is designed to handle the typical residential pool that is between 15,000 and 40,000 gallons. It is comparable in application to the AquaRite AR-4000 or the Ecomatic ESC-36 unit.
It can be used on either 115 or 230 volt systems.
Input:
115 VAC, 50/60 Hz, 2.5 amps
230 VAC, 50/60 Hz, 1.75 amps
Output:
22-30 VDC @ 6 amps maximum
Chlorine:
1.25 Lbs per 24 hour (567 gm / 24 Hr.)
Warranty
The AquaPure system carries a 5 year limited warranty on a prorated basis. Since warranty terms can change from year to year on any product, please contact us at pintos@optonline.net for the most up-to-date information on this product.
